140
Lighting
Entry lighting
3
After unlocking the vehicle, the instrument
and switch lighting come on for a few
seconds.
Door handle lighting
3
When the exterior lights are on, the interior
front door handles are illuminated.
Illuminated mirror in the sunvisors
3
The lighting switches on when the cover is
opened.
Glove compartment lighting
on when lid is open.
Cigarette lighter and ashtray
illumination
3
Comes on when ignition is switched on.
Luggage compartment lighting
Comes on when the boot lid / tailgate is
opened.
Automatically regulated centre console
lighting
3
Spotlight in housing of interior mirror.
Daylight-dependent, automatically
regulated centre console lighting with
ignition switched on.
Puddle light
3
After unlocking the vehicle, the number
plate lights come on for a few seconds.
Battery discharge protection
To prevent the battery from becoming
discharged, the courtesy light, reading
lights, luggage compartment lighting and
glove compartment lighting switch off
automatically 10 minutes after the ignition
is switched off.
Light covers
The inside of the light covers may mist up
briefly in poor, wet and cold weather
conditions, in heavy rain or after washing.
The mist disappears quickly by itself; to
help, switch on the lights.
Headlights when driving abroad
The asymmetrical dipped beam increases
the field of vision on the passenger’s side of
the lane.
This causes glare for oncoming traffic if the
vehicle is driven in countries where traffic
drives on the opposite side of the road.
Do as follows to prevent glare:
Vehicles with halogen headlight
system or Xenon headlight system
3
Have the headlights adjusted by a
workshop. We recommend your Vauxhall
Authorised Repairer.
Vehicles with Adaptive Forward
Lighting
3
(
AFL)
1.
Pull and hold stalk for main beam on
steering wheel (headlight flash).
2.
Switch on ignition.
3.
After approx. 3 seconds, an acoustic
signal sounds and then AFL control
indicator
B
flashes approx. 4 seconds.
After the switch, AFL control indicator
B
flashes for 4 seconds each time the ignition
is switched on.
To return to asymmetrical dipped beam,
pull and hold the main beam stalk again,
switch on the ignition and wait for the
acoustic signal. AFL control indicator
B
will then discontinue flashing.
Control indicator
B
–
see page 42.